Lake Shore Live Steamers > Images


Work Session - 6/04/14


I headed down to the Truss Bridge to drill the signal posts for targets and found that Jerry Bell is putting a switch in at the end of the Justin Tyme Bridge. I am replacing the lower reflector with a larger one.
I had only brought high-speed drill bits and I was beginning to wonder if the signal post was made out of bed frame steel, it took the longest time to drill two holes with a battery-operated drill. The photo taken without flash, you can see one yellow reflector at the extreme left and one at the extreme right on the signal post.
Two yellow reflective targets, two posts and scratch one high-speed steel quarter inch bit. I took so much time trying to drill four holes that I missed what the guys were doing up by the station and the leaf blowing.
                                               
This site is copyright 2000-2018